HX-SZ100-SYNCDIM-TOUCH, adopt the most advanced PWM (Pulse Width Modulation) digital dimming technology, especially design for single color led strip. Adopt full touch RF remote control. 5 function buttons and 1 dimming ring in the center, all buttons are in the touch form, and the dimming ring has 128 levels in different brightness value. Particularly, there is a sense light in the remote control center. It shows the exactly light which was be touched. As the led strip is the same brightness level. Further, there are 3 dynamic modes in the mode button, and the speed is adjustable. In order to achieve the market need, the synchronization work of more lamps, it is designed the conjunction-sync-work function with RJ45 connecter, user-friendly.

Product Feature

l  Adopt PWM technology, dimming from 0% to 100%, smooth and flicker-free.

l  PWM signal frequency:2KHz.

l  High watt output design, up to 300W/CH.

l  Easy connection to achieve multiple dimmers sync-work by RJ45 terminal.

l  Adopt RF remote control technology and full touch design.

l  Designing for: LED constant voltage single color product like LED single color strip.

l  2-year warranty.

InterfaceSpecifications 

Direction for use

Adopts RF full touch control, with onedimming ring and 5 function buttons.

Tips: Without any operation more than 6seconds, the touch remote will enter the sleep state, please  SHAKE the remote to wake up it before the nextusing.

RF CODE

Tips: Receivercan be controlled by any one the same remote as factory default; full touchremote control delivered with unique RF code as factory default; ifunique-control is needed, please matching the code before installation and using.

Matchingcode operation

If unique-control or new-coded-remote is needed, pairingthe remote and the receiver as below operation instruction before using:

1.     Step 1: Pressing key “Mode” and hold on, power on the controller, theload LEDs will be 50% brightness white as responding.

2.     Step 2: Continuously to press the key “ON“ for 3 times within 5 seconds after step 1 ,the brightness of LEDs willchange from 25% -10% as responding.

3.     Code learning successfully, the LEDs will be back to the statusbefore the power off, and the receiver only can be control by theremote.

4.     If not, please re-operate from step 1 to 2.

Clear codeoperation

Back to factory default, wall-panel can be controlled byany one the same remote control.

1.      Step 1: Pressing key “Mode” and hold on, power on the controller, theload LEDs will be 50% brightness white as responding.

2.      Step 2: Continuously to press “Speed/Brightness-“3 times within 5 seconds after step 1 ,the brightness ofLEDs will change from 25% -10% as responding.

3.      Code clearing successfully, the LEDs will be back to the statusbefore the power off, and the receiver can be controlled by anyremote control(any one the same remote control can be used to clear the code).

4.  If not, pleasere-operate from step 1 to 2.

Typical Applications

Conjunction diagram :

Productinformation for placing order