HX-RFBT002-RGB

RF BT remote controller-RGB

HX-RFBT002-RGB, adopts the most advanced PWM (Pulse Width Modulation) digital control technology, it is used for controlling constant voltage LED RGB lamps. For instance, point source of light, flexible light strip, led modules, led strings and so on; It belongs to low-voltage DC power input and output with four interfaces, including + V is extremely common interfaces, the other three for the RGB control interface. Meanwhile, you could adjust brightness, static color choices and various dynamic changes in lighting effects through RF 14keys remote control. In addition, It is convenient to use RJ45 connector to connect the multiple controllers together, and achieve the synchronization function of thousands meters led strips. In theory, they can be connected numerous.

Product Features

l Designed for RGB constant voltage LED lights,Working voltage DC12-24V.

l Three channels output, Max. load current: 3CH*8A;Max. load power: 288W/12V; 576W/24V.

l  AdoptsRF 14keys remote control with fashion appearance, no need line-of-sight. Controlrange up to 20 meters.

l  Memoryfunction, each time power-on reserve the mode which stop in the last power-down.

l 18 modes in total, including 8 static colorsand 10 dynamic changes.

l The brightness of static color is adjustable,256 levels in total; the speed of dynamic changes is adjustable, 100 levels intotal.

l Long-press the brightness and speed key canget the fast adjustment, convenient for operation.

l Multiple controllers can work synchronicallywhen connected by network cable through the RJ45 connector, the network cablebetween 2 ports up to 80 meters.

l Warranty of this product is two years, excludethe artificial situation of damaged or overload working.

InterfaceSpecifications 

                                                                                                                                           RGBConnection：V+→COM、CH1→R、CH2→G、CH3→B；

Direction for use

l  Connectthe load wire at first, followed by the power wire; Please ensure short circuitcan not occur between wires before turning on the power；

l  AdoptsRF remote technology, 14 buttons in total;

l  Thesignal light flash-- represents the signal has been received well;

The function of buttons are shown as below:

Matchingcode operation

If unique-control or new-coded-remote is needed, pairingthe remote and the receiver as below operation instruction before using:

1.     Step 1: Pressing key “set” and hold on, power on the controller, the load LEDswill be 50% brightness white as responding.

2.     Step 2: Continuously to press the key “Hotkey for white color “ for 3 times within 5 seconds after step 1 ,thebrightness of LEDs will change from 25% -10% as responding.

3.     Code learning successfully, the LEDs will be back to the statusbefore the power off, and the receiver only can be control by theremote.

4.     If not, please re-operate from step 1 to 2.

Clear codeoperation

Back to factory default, wall-panel can be controlled byany one the same remote control.

1.      Step 1: Pressing key “set” and hold on, power on the controller, the load LEDswill be 50% brightness white as responding.

2.      Step 2: Continuously to press “Dynamicauto-cycle “ 3 times within 5 seconds after step 1 ,the brightness of LEDswill change from 25% -10% as responding.

3.      Code clearing successfully, the LEDs will be back to the statusbefore the power off, and the receiver can be controlled by anyremote control(any one the same remote control can be used to clear the code).

4.      If not, please re-operate from step 1 to 2.

Typical Applications 

Product information for placing order